avionic design with actual uboot and tooling

submodule of avionic design uboot bootloader and with included tools to
get you started , read readme.md and readme-tk1-loader.md

u-boot/board/bf527-ezkit/bf527-ezkit.c

@@ -0,0 +1,72 @@
+/*
+ * U-Boot - main board file
+ *
+ * Copyright (c) 2005-2009 Analog Devices Inc.
+ *
+ * Licensed under the GPL-2 or later.
+ */
+
+#include <common.h>
+#include <config.h>
+#include <command.h>
+#include <net.h>
+#include <netdev.h>
+#include <asm/blackfin.h>
+#include <asm/gpio.h>
+#include <asm/mach-common/bits/otp.h>
+
+DECLARE_GLOBAL_DATA_PTR;
+
+int checkboard(void)
+{
+	printf("Board: ADI BF527 EZ-Kit board\n");
+	printf("       Support: http://blackfin.uclinux.org/\n");
+	return 0;
+}
+
+#ifdef CONFIG_BFIN_MAC
+static void board_init_enetaddr(uchar *mac_addr)
+{
+	/* the MAC is stored in OTP memory page 0xDF */
+	uint32_t ret;
+	uint64_t otp_mac;
+
+	ret = bfrom_OtpRead(0xDF, OTP_LOWER_HALF, &otp_mac);
+	if (!(ret & OTP_MASTER_ERROR)) {
+		uchar *otp_mac_p = (uchar *)&otp_mac;
+
+		for (ret = 0; ret < 6; ++ret)
+			mac_addr[ret] = otp_mac_p[5 - ret];
+
+		if (is_valid_ethaddr(mac_addr))
+			eth_setenv_enetaddr("ethaddr", mac_addr);
+	}
+}
+
+int board_eth_init(bd_t *bis)
+{
+	return bfin_EMAC_initialize(bis);
+}
+#endif
+
+int misc_init_r(void)
+{
+#ifdef CONFIG_BFIN_MAC
+	uchar enetaddr[6];
+	if (!eth_getenv_enetaddr("ethaddr", enetaddr))
+		board_init_enetaddr(enetaddr);
+#endif
+
+	return 0;
+}
+
+#ifdef CONFIG_USB_BLACKFIN
+void board_musb_init(void)
+{
+	/*
+	 * BF527 EZ-KITs require PG13 to be high for HOST mode
+	 */
+	gpio_request(GPIO_PG13, "musb-vbus");
+	gpio_direction_output(GPIO_PG13, 1);
+}
+#endif